Router CNC,Ruteado CNC - ROC
Send Mail Skype Call Add MSN







Lista de Productos



1. DSP controller dies
   Update the DSP controller programe with the update file
          Use the manostat (UPS) for the machine
2. The machine doesn't go home (the limited sensor is not working).
   Check the DSP cable connector if some pins are bended
          Restart the mahcine
   Use a new DSP controller
   Check the DSP parameters if there are some mistakes   
3. Machine moves to the opposite direction
          The DSP cable maybe loose and you can check the cable.
   Change the wire terminal A+ and A- (or B+ and B-) on the driver
   Change the cable connected with the limit switch
     Change a new red limit switch
4. Main spindle doesn't run
      Voltage is too low and use the manostat (UPS) for the machine
  Check the cable connected from the Inverter to the spindle
  Check the Inverter parameters is there are some mistakes
  Check signal wire from the DSP board to the Inverter
5. Machine doesn't work accurately 
     Check the parameters for the DSP settings, the pulse value
        Check the driver parameters
  Use ground wire
  Fasten the linker of the screw ball or the gear and pinion space
6. Engraving size is not right
   Same way as term 5
7. Machine doesn't work after swich on (including the machine don't go home)
      The switch is broken, change a new switch
  Check the power connector and power supplier
  Check the cable connected with the switch and pin in one end of the cable
8. Machine strikes sideward peg when it is working
   The sensor switch is over or the sheet copper of the sensor switch is distort, change a new  sensor switch or fix the sheet copper
  The dimension of the machine in controller is not right, reset the dimension according  to the working size 
9. Blade is broken when engraving
  Lower the engraving speed you can press Y- when the machine is working
  Decrease the engraving septh of one pass
  Collet is in a wrong position and corrects it
      You can grind the blade with the grind machine
10. There are some leftover of the material when the machine is working.
  Rectify the interspace of the screw of every axis in DSP: SCREW INTERSPACE
  Fasten the linker of the ball screw (for ball screw machine)
11. Red sensor switch is ok but can't stop the machine
  Sensor switch is dirty and clean it
  Sheet copper is too far away from the red sensor switch, the best distance is 1mm
12 Add machine in soft ware TYPE3
  Open the TYPE3, and find the machining=> set up machines =>choose the ISO ISEL in CNCmachines=>ok
13 X-axis or y-axis doesn't move
  Usually it is the problem of the stepper motor, driver and cable connected with the x-axis or y-axis, check them and correct
14 How to protect the table of vacuum machine
  Don't hollow out the material when engraving
15 How to change Chinese version to English (DSP)
16. How to change the language of TYPE3 from Chinese to English
  Open the soft ware type3 and press the button F10. It will appear option windows. You can choose English.
17. Maintenance
  Clean the machines everyday after work
        Lubricat with the grease every week, just one time push on the gease system and add 1#  or 2# oil, or the grease on our web
    Check the drive components very month when the machine is working, to ensure every party is working under best condition, like the wires, motors, drivers or spindle.




 ©CopyRight Roctech Machinery Co., Ltd.
400-005-8823 / +86 531 86085880 FAX:+86 531 86087880
ADD.:Room 201,Mingzhu International Business Center,#88 Jingyi Road,Jinan,Shandong,China